SoFloTC

iTrader: (3)

hahaha

java09

turbotoyotas!

Twilight2ner

iTrader: (6)

woooo back on topic lawls

flintMicaTC

Turbotoyota's

java09

aaaaaaaaaaaaahahahahahahaaaahhhhahahahahahahahahahahahahhaha

El turbotoyotas me gusts!

toyota_scion_tc

For all the folks saying TT is working on everything and it should be straighten out, I have heard this for 3 months now!

20tCDude05

Just lock this thread, this is going nowhere.

toyota_scion_tc

Sorry dude, best advice stay away from TT for a while they have too many issues to work out. Go with Dezod or Ptuning if they come out with a kit before you are ready.

20tCDude05

I do have a Dezod kit, but I just want 3" downpipe, 3" s-pipe, 3" exhaust, and EL manifold.

paul_dezod

Get yourself just a good exhaust and watch your numbers sky rocket.

toyota_scion_tc

Ptuning for the 3" exhaust, this is what is going on my setup the exhaust is already sitting in my garage.

20tCDude05

I don't like their tip though. I am afraid it won't bolt up to TurboToyota`s 3" downpipe and 3" s-pipe. I asked Mr. C if he could use the current muffler I have, 3" inlet HKS Carbon-TI and weld that onto their exhaust for the angled look like EVOs and STIs have and no response.

rhythmnsmoke

^^of course you would cut it and weld on what you want. I don't see why that would be a problem. Did it to my ZPI exhaust.

20tCDude05

Depends on how the last bend is, it determines the angle right?

rhythmnsmoke

No, you would tell your exhaust shop where and how you would like for the muffler to sit, and then they would cut the exhaust pipe at the angle and create basically a new axle back section that would weld up to the rest of the exhaust system.

java09

^travis is right.. any good muffler shop would have no problems doing that for you at all.

it comes down to how good the muffler shop is because you want good welds and no crazy bends in the new fabrication!

20tCDude05

Ok, wonder if anyone would buy the PTuning 3" axle back in replacement of my muffler. That sounds like a good idea. I don't want their s-pipe because it may not fit with TT`s 3" downpipe. Think TT`s 3" downpipe and 3" s-pipe will fit with PTuning`s 3" catback?

flintMicaTC

from what todd told me since i have the ptuning exhaust, is that they will not line up right, either the downpipe or spipe need to be modified in order to fit right, but we'll see when my kit comes in?? i dont have ptuning's spipe so we'll see

CarbonXe

iTrader: (1)

My PTuning Spipe matched up with my TT 2.5" downpipe just fine with a donut gasket in between.

rhythmnsmoke

^^Guess that solves that question.