has anyone ever made a cubby hole for their coilovers in the rear, i wanted something similar as the tail light panels. any diy on this? Post pics if you have them. thanks.

 

i want something where you can open and close, not just a cutout. im pretty sure thats what everyones doing, but i want some panels.

 

I am chaning to ss-ps soon and actually started tossing around the idea of cutting that out and molding fiberglass t omake a nice looking hole there that blended into the plastic... but I probably wont :D For now I will just leave out the panels until I get the damping set where I want it and then button it all back up. I would use edfc, but that is technically a no-no for autox.

 

yea i had the same basic idea, ill probably figure something out, maybe put some molding i dont know ill figure it out this weekend lol. The edfc is nice to have but i would not rather spend the money when i can just adjust it myself, but it must be nice to adjust it inside your car while its moving.

 

I just cut a square hole...

it does the job lol