I just finished installing an LED swap for my 07 tC. I installed in groups, first the hvac, then wheel controlc then gauge cluster.

After finishing the gauge cluster I keep blowing a 7.5 fuse when I turn my lights on. It shows the lights dimmed for a sec then the fuse blows and it goes back to full brightness. Blew 3 fuses comfirming.

Any idea where I should be looking for short or bad solder job? I felt I did a very good job soldering the gauge cluster too.

 

something is touching, something its not suppose to

 

I found it, think I had a wire pinched in my steering wheel, also had a bad LED which ever it was its fixed now.

 

check your soldering.

 

I reflowed all my solder joins while I had it out just to be safe.