Hi everyone, I have searched around, but found nothing. I have gutted my tC and I am about to start putting led's in the cupholders and such, but i was curious about what drill bit size to use? They are 5 MM leds.

 

So 3/4"?

 

3/16 for a 5mm

 

That will let the led in, but not the base?

 

right, perfect fit and it wont come out

 

Awesome! Thanks so much!

 

no prob

 

oh boy, cant wait to see this thing at S3! i SHOULD have all my over lays on for it too!

 

I was trying to figure out what the heck a LED drill bit was.

 

The drilling went perfectly, once i get my camera back tomorrow, i will show the glory that will soon be my lit up car, though its all in pieces.

 

But the pieces are glowing now.

 

Indeed they are, i need to go get 4 Gatorade bottles. They hold the light very well.

 

ahh... pretty much finished finally hmm?

 

Yep, i just test them in, they all work, they are hot. I also prewired my car for cathodes in the rear, and wheel well led's. So its gonna be pretty easy to put more stuff in.

Question, should i put led's in the grocery hook spots?

 

warning on wheel well leds... i have the street glow kit, and now that im on stechs and 19s you almost cant tell they are on... i know your gona g with 18s though, so you may get better light transfer...