I have my soldering iron all heated up and was about to swap the leds until I noticed they were different. The difference in size did not startle me, however. It was the fact that I could not locate a mark of polarity in which would be direction to solder the new leds. My question is how do I now which way the new leds go in if the old ones have no markers?

 

hey.. don't hesistate to call me next time..

and for those just joining in and not sure as well...

"K" is for cathode... (-)..

 

I was embarrassed to call you Thanks again though man, you know your stuff! That is a good thing to know for other people when they are doing the swap. Thanks again man, I really do appreciate it!

 

hey... sometimes i'm not on the computer you know..

 

swap is done! It looks amazing, much brighter than stock and than I expected. The blue looks really nice. I left my door panels on the grass while soldering in my house when it was getting dark and when I was putting them back on I noticed two slugs on the plastic! I flicked em off with my finger and finished the install to check out another successful install. Everything is so far so good - hvac with engifineer mod up tomorrow!