hey guys, I got two questions. i just got an ati gauge pod, and i dont think many people have these but for those that do I was wondering how u guys routed your gauge wires through the back of the pod to under the dash?

my other question is that i just got the aem uego wideband gauge and it says it needs a switched positive feed with a 10a fuse on it, so would it be ok to tap into my ignition power and just put an inline 10a fuse on it, or would it be better to put in a toggle switch and run a hot line to that and then an inline 10a fuse from that to the gauge?

 

wow does anyone have any info?

 

just feed the power from the back or the cigarette lighter with a fuse if you want, thats the easy way

 

true. yeah that sounds pretty simple, does anybody know how to run the gauge wires down from the ati pod?

 

I was gonna buy the ati pod but it looks to much of a Ricer then so im getting pods on the side. Just take apart the center console and remover the radio and find a safe spot to drill your hole(s), try avoiding the AC vents.

 

man do u think there is any other way to do it without drilling holes? yeah im not a huge fan of the look of the pod either but the a pillar pod says not to use with the curtain bags and i have them. and its the only other pod i can use thats like even close to being in view so ya know, had to get it lol.

 

Yea i know wut you mean, thats y i bought a stock tc. Drill one hole in the middle to the correct size you need. When you wat to remove the pod then put like led alarm status lights there. Is the pod attached by 3m tape? i think it needs 2 screws right?

 

well i actually just got it in the mail 2day and havent even seen it, its at my dads house lol. but yeah it says that it can be put in with just the 3m tape, thats why i figured it didnt need to drill any holes, it was kinda the perk of it all considering its not the best looking pod.

 

Its ok, not the best but if it does the job ts fine. Wut mods do you have and gauges? I want to get the carbon fiber 2 gauge pod and put in voltage(subs) and oil temp(drive crazy). I wish it came with a third pod so i could put oil pressure

 

yeah i got all my mods listed in my profile if u check it out, but im thinkin bout getting the autometer gauge thats like a digital tac and shift lift so i can fill the third slot. so far i got my ghetto sub setup lol, got it all from my brother and friends, but its actually an awesome setup, nothing like rokeford products before they went mainstreem. but i do have fres jbl power series highs.

 

you can use the a-pillar gauge pod if you have the curtain air bags.

 

Damn you have alot of mods, i dont see pix of the supercharger. Yea there are models of the a pillar gauge pods the go on top of the pillar

 

really? then y do all the manufacturers say that u cant?

 

yeah i dont have a good digital cam yet, and im in the middle of polishing it out (my batt. charger for my drills died) but yeah its fun, well where do they run the gauge wiring down though when they have an a pillar pod? couldnt i use the same spot?

 

so anybody know where to route the wires?