ok so i have noticed rather at work, parking it after 3o minutes of driving my upper grill likes to try to run away... it is a stock grill and i never wrecked it in anyway for it to be acting this way... so i tried several things to keep it in place i even tried putting my knee on the bumper and pressing it in from the inside but it still pops out.. it is aggravating.. i took it out once already to see what the deal was and everything seems ok. the lower part of it will click into place but... moments later unclick then later i wind up sticking my fingers in holes and popping it all back into place....

Has anyone had this issue or know how to resolve this? i have no clue how or why it is doing this so........ any advice is useful and or helpful

 

ive had the same problem.Mine seemed like the bumper warped a little bit or something. To fix this, i went on the inside of the bumper and jammed small pieces of wood (thats all i had) under the tabs on the bumper that normally latch on to the grill. I havnt had a problem since. I hope that helps, if you dont get exactly what im talking about PM me. ill send some pics or something.

 

Zip ties

 

Will cardboard work? If so Ill have it done quick

 

REDACTED

 

I have gone to super glueing it in. Trying to find some cheap VRDs so I can take out the stock grill and epoxy those in.

 

Pics are needed sending pm

 

Ok so right after I posted on here I discovered that I still had my box my fogs came in. So I looked inside and found out there were these cheese puff like stuff inside so I took them and wedged them in there I'll see how it works out and post back again. They seem as if it'll hold pretty good. Plus I took another look at the grill the holes that connect it to the bumper are broken so that explains why it won't hold. But if this stuff holds I can save some money up and get a new one

 

Ok so today was a great test for the popcorn stuff. i drove 70mph down the interstate then drove regularly on the way back it works out great!!! plus it was very windy today. but i will have to see how it holds up in the rain before i jynx it hahhaa!

here are photos of the inside where i stuffed them in all along the grill (corner to corner):

 

sorry i couldnt send pics, ive been busy the last few days. Thats exactly how i did mine though. that should hold up well but after a while i think those might just break down over time

 

HAHA you were right the popcorn things evaporated so now i am stuck and I don't have any wood pieces laying around i'll have to find some from a pallet at work tonight to make them work. would try zip ties but not sure on how I would do that.