aryan13

iTrader: (1)

So every time I accelerate or drive up a steep incline my emergency brake light comes on. Not really a problem more of just an annoyance. Wondering if anyone has a suggestion on how to fix.

c500129

iTrader: (1)

Check brake pads and fluid. Brake pads are worn down or fluid is low. So when you accelerate or go up something steep it's flowing back further. Happens to me everytime it's getting ready for new brake pads.

aryan13

iTrader: (1)

Isn't emergency brake separate from our normal brakes

kungfu tc

Happened to me also. Just needed brake fluid

CSOCSO

iTrader: (1)

Pads.... fluid is low because pads worn out. If u refill than later if you change the pads you will have fluid gushing out in the engine bay. Not good

Sent from my SPH-L710 using Tapatalk 2

c500129

iTrader: (1)

nah, brakes are brakes. you adjust your hand/e-brake through the rear brakes when you change pads.

Jackieee_tC

They are separate aren't they? E-brake is controlled by a cable, while front and rear brakes rely on fluid. Also, the E-brake is not adjusted with the rear brake pads. Brake shoes are housed within the hat of the rear rotor for the tc1.

pinoyFMtC

Correct.

Even though the E-brake and the regular braking systems are separate mechanically, the "BRAKE" light should also come on when the fluid in the reservoir is low. Usually the fluid level goes down when the pads wear down, but it could be something else also. On the tC I've seen the light come on temporarily when starting to accelerate from a stop; In this case, the pads were low.

JonnyG

Ditto on what he says. But if you messed up, like I did, and added brake fluid before brake change, just siphon some brake fluid out. I used a turkey baster to do that

lightwarp

i have the same problem, but it's not the fluid or pads (i checked after reading these posts). how is this possible? any other guesses?

mrtribble

Mine did this last week when I would take off hard. The fluid didn't look low but I topped it off and if hasn't came back on.

SoulXquisite

your not suppose to top of brake fluid, your brake pads wear down so it replace the space in the brake caliper with brake fluid from the reservoir, so your reservoir looks like it is going down. So check the brake pad thickness. probably means either the front or rear (possibly both) pads need replacing soon. Adding Brake fluid because the the E brake light turns on during hard acceleration will stop the light from coming on, but then you will forget that you added fluid and then your non existent brake pads will grind metal on metal.

mrtribble

I put a full stoptech drill brake kit on my car with ss lines and all I may not have topped the fluid off but my pads are brand new