TRD shocks and springs uneven?
so i just got my trd shocks and springs installed a few weeks ago by gabe at precision muffler. they set was used so i did not expect them having to settle in. now the rear i can fit in about 2 fingers while in the front i can get 3 fingers in. now is there any reason for this or are the trds just like this? also whenever i go up driveways and stuff i can hear a creeking noise comming from the rear pass side. please help me out w/ possible solutions to these problems thanks..
The tC's front wheel wells have larger openings in the front that the rears...this gives the effect of the front of the car sitting higher. If you had measured the height of the top of the fender openings in relation to the ground before and after the install, you would have seen that the drop is in fact even.
Thread
Thread Starter
Forum
Replies
Last Post
DJ_FroZone
Scion xB 2nd-Gen Owners Lounge
25
May 30, 2019 07:17 PM
fluxingnation
Scion xB 1st-Gen Owners Lounge
1
Dec 26, 2014 04:28 PM
swtbabiboi4u
Scion xB 1st-Gen Aero & Exterior
2
Oct 10, 2003 01:40 AM







