Borla Axle Back issues on 2016 Scion tC - Scionlife.com

Notices
Scion tC 2G Drivetrain & Power Engine and transmission discussions...

Borla Axle Back issues on 2016 Scion tC

Reply

 
 
 
Old 07-11-2018, 04:27 PM
  #1  
Junior Member
Thread Starter
 
Join Date: Jul 2018
Posts: 1
Question Borla Axle Back issues on 2016 Scion tC

Hi there, I recently installed a new Borla axle back exhaust onto my car. Everything seems to be done properly however the exhaust to doesn't seem to hang properly. The exhaust tip hangs a few inches lower than it should be. Any suggestions??


MikeMakinson is offline  
Reply With Quote
Old 07-12-2018, 08:11 PM
  #2  
Senior Member
SL Member
 
drizzoh's Avatar
 
Join Date: Jan 2016
Location: AZ
Posts: 159
Default

Grab shorter exhaust hangers. You can replace the 2 rears with shorter Torque Solutions urethane ones and that should bring it in tighter. I bought the full set of 5 and threw them on when I did my Tanabe axleback. Hangs nice.


Last edited by drizzoh; 07-12-2018 at 08:24 PM.
drizzoh is offline  
Reply With Quote
Reply
 
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
PTUNING
Exclusive Sponsored Sales
4
08-15-2011 06:42 PM
661DIPSETtc
PPC: Wanted
3
03-07-2010 08:42 PM
babyfac3pn01
PPC: Engine / Drivetrain
6
01-07-2010 09:24 AM
HulksXb
Scion xA/xB 1st-Gen Drivetrain & Power
11
07-10-2006 12:55 AM
chadfo
Scion xA/xB 1st-Gen Drivetrain & Power
13
05-28-2004 03:56 AM


Thread Tools
Search this Thread