Raceland Coilover Install SUCCESS!
Finished my install today and holy ____ was it hot out! I am mentally and physically EXHAUSTED! 8 hours and 30 glasses of water later...
Here's some photos...

[IMG]http://i112.photobucket.com/albums/n194/EthanAJS/P1011826.jpg[IMG]
Before, Front and Rear.


After, Front and Rear.


I rode about 20 miles on them so far and my only problem is I need two push pins to connect the plastic and metal cowl that go at the bottom of the windshield, it vibrates at highway speed sometimes. Also, my front right creaks a little when I make a tight turn, so I will let these settle for a few weeks and get an alignment and check the torques again.
Shout out to my buddy Justin, without him it wouldn't have been possible, and to Raceland for making affordable 3 inch drops with 3 day shipping!
Here's some photos...

[IMG]http://i112.photobucket.com/albums/n194/EthanAJS/P1011826.jpg[IMG]
Before, Front and Rear.


After, Front and Rear.


I rode about 20 miles on them so far and my only problem is I need two push pins to connect the plastic and metal cowl that go at the bottom of the windshield, it vibrates at highway speed sometimes. Also, my front right creaks a little when I make a tight turn, so I will let these settle for a few weeks and get an alignment and check the torques again.
Shout out to my buddy Justin, without him it wouldn't have been possible, and to Raceland for making affordable 3 inch drops with 3 day shipping!
Last edited by EthanAJS; Jul 3, 2013 at 05:02 AM.
Thread
Thread Starter
Forum
Replies
Last Post
scionlife
Scion xA/xB 1st-Gen Suspension & Handling
10
Mar 1, 2016 09:14 PM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
Dec 2, 2003 04:53 PM





