Muffler Help
hey i turned to you guys for help i was thinking on puting a high flow cat and 2 1/4in pipeing with an apexi N1 muffler anybody have any comments on this setup I wanted some sound out of it and i wanted a bit hp out of it 2 but im open for comments thanks
Guest
Posts: n/a
ok, you need to make sure that you are getting the right cat on the car, because the converter we have is small already and the converter we have is a three way converter. So just grabbing any high flow will cause you not to pass smog. Also, if you are going to lower your car in the future, you may want to get another muffler. The Apex is a 7in round muffler with a tip in the middle, allowing the belly of the muffler to rest just low enough to scrap on driveways. That is why a lot of mufflers made for our cars has the tip seperate from the muffler. Check out my exhaust and let me know what you think.
http://scionxb.net/index_files/styli...is_exhaust.htm
http://scionxb.net/index_files/styli...is_exhaust.htm
Careful about the aftermarket cats. the flow is really good for the 96 and newer cars but the cat on our Xb is small enough to maintain a good flow. The 5Zigen rear section for the car is an excellent exhaust. The tone quality is deep and the improvement is noticable above 25K. I drive between 25 and 4K anyway.
then i dont know what i shoud do i wanted a bit more sound out of it that magnaflow u have is a bit silent so i wanted something diffrent then i was thinking of an apexi or and skunk 2 so then i dont know again they hang to low so i dont know what i shoud put on there the blitz nur spec is good 2 but then other pepole say its crap so i have no i dea on what to do
Thread
Thread Starter
Forum
Replies
Last Post
Hydryman
Scion tC 1G Owners Lounge
9
Feb 23, 2016 03:35 PM
rancur3p1c
Scion tC 1G Drivetrain & Power
1
Jul 12, 2015 07:59 PM






