7" visor LCD screens installed *pix*
Took me at least 20 hours. Lots and lots of steps. But it came out great :D
I now sell the screens for $180 and will add more mobile video to my store soon.
I made a very detailed how-to guide with many photos. Check it out here: http://www.oznium.com/articles/11

I now sell the screens for $180 and will add more mobile video to my store soon.
I made a very detailed how-to guide with many photos. Check it out here: http://www.oznium.com/articles/11

Pyle.
Yes, Pyle is known as a bad brand. I wouldn't dare use pyle audio equipment, but their LCD screens are an exception! They are comparable to valor, eigervision. Clarion is probably a notch above in quality of the picture, but it is twice as expensive!
Yes, Pyle is known as a bad brand. I wouldn't dare use pyle audio equipment, but their LCD screens are an exception! They are comparable to valor, eigervision. Clarion is probably a notch above in quality of the picture, but it is twice as expensive!
Thanks for the how-to!
I have a Pyle in-dash TFT screen (PLVIN70) that gets lots of compliments for image quality. I'd have no reservations about buying another Pyle screen.
'Fraid the same couldn't be said about the rest of their product line, though ...
I have a Pyle in-dash TFT screen (PLVIN70) that gets lots of compliments for image quality. I'd have no reservations about buying another Pyle screen.
'Fraid the same couldn't be said about the rest of their product line, though ...
lol. nice install dude! i think i might install 1 monitor i have in dash, and 1 in visor like u did
.
With that setup, did u have to run 3 wires to a control box that sends signals to the screens. My kit has 3, a red, yellow, and black. i'm havin problems, read this post please:
https://www.scionlife.com/forums/vie...=724538#724538
.With that setup, did u have to run 3 wires to a control box that sends signals to the screens. My kit has 3, a red, yellow, and black. i'm havin problems, read this post please:
https://www.scionlife.com/forums/vie...=724538#724538
I had essentially 5 wires. Power, Ground, video 1, video 2, and video 1&2 common. Maybe the yellow wire you are talking about goes to the RCA video source. You could try hooking up red and black to the power and ground and see if the screen turns on.
i tried that, the red,yellow,black wire goes into a three pin plug that goes to the control box/inverter. then a cable goes out to 1 tv, and another cable goes to other. and then there's an input cable i have with composite hookups. i'm gonna go see what i can come with.
Thread
Thread Starter
Forum
Replies
Last Post
mattjk
Scion xA/xB 1st-Gen ICE & Interior
121
Dec 22, 2004 10:49 AM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
Dec 2, 2003 04:53 PM







