Another install question
#1
Senior Member
Team Sushi
SL Member
Team N.V.S.
Scion Evolution
Thread Starter
Join Date: Jun 2004
Location: Bangkok, Thailand
Posts: 4,322
Another install question
Sorry, I know you guys get a butt load of these questions, but I read that on an amp install for an xB you should not tap the rear outputs from the deck, because they have a seperate amplifier. Is this true? I don't want to sap the signal strength for an line out converter from the front speakers, since that output already drives the tweeters too. . . is there actually a seperate amplifier(sounds weird) and is the xA like this too?
#3
You will be fine tapping off the head unit, a easier way to do it is to just tap off the back speakers t-tap in the wires. I did this because I knew it was temporary until I got a new head unit.
As far as your amp goes you should be fine I was running a 1000watt Hollywood Sound Amp in the storage area. I always ran it hard it only shut off on me once on the way to vinyl mayhem (about a three hour round trip).
As far as your amp goes you should be fine I was running a 1000watt Hollywood Sound Amp in the storage area. I always ran it hard it only shut off on me once on the way to vinyl mayhem (about a three hour round trip).
Thread
Thread Starter
Forum
Replies
Last Post
wiltonhall
Scion xA/xB 1st-Gen ICE & Interior
2
01-28-2015 03:46 PM
Beesh
Scion xA/xB 1st-Gen ICE & Interior
3
01-09-2015 06:30 PM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
12-02-2003 04:53 PM