invisaGAURD headlamp and bumper protection kits
#1
invisaGAURD headlamp and bumper protection kits
if any of you guys are wondering about protecting your headlamps or front bumper, I would HIGHLY reccomend this product. Its cheaper Than "3M" installers- and at $160 for a bumper and hood kit- its very affordable.
currently I have the headlamps only- but soon I will have the whole kit!
http://www.autotrimdesign.net/items.jsp?category=10942
The have kits for all scions....
currently I have the headlamps only- but soon I will have the whole kit!
http://www.autotrimdesign.net/items.jsp?category=10942
The have kits for all scions....
#4
As a painter I have had to deal with then a few times. They do work. But if you get a ding on one side and the "lot Boy" is not carefull when removing it, It can ruin the paint it covers. Also you will have to learn to live with the dirt line that will collect at the edge. And no, it will not just wash off. The material will shrink about a half of a Millimeter or a bit less exposing the adhesive that will hold the dirt.
#5
The headlight kit is a must. I already have a small chip on the one of my headlights $40 doesn't sound that bad. But I am waiting on weathetech and whether they will seel an xB LampGaurd. There's is 40-mil thick. The invisiguard is 15-mil thick.
Here's one on a LandCruiser...only $45.
http://www.weathertech.com/store/veh...pt_choice_id=0
Here's one on a LandCruiser...only $45.
http://www.weathertech.com/store/veh...pt_choice_id=0
#6
I ordered the headlight gaurds from them when I bought my XB. My Subarus headlights are really pitted & chipped and it would cost several hundred dollars to replace them. I figure if I have to replace the film a few times over the life of the XB it won't hurt my wallet so much.
The installation was pretty easy, but I did have to do some custom trimming to make the film lay flat in some places. They came pretty quick, but you have to print the installation instructions from the website.
The installation was pretty easy, but I did have to do some custom trimming to make the film lay flat in some places. They came pretty quick, but you have to print the installation instructions from the website.
Thread
Thread Starter
Forum
Replies
Last Post
viciouzgamer
Scion tC 2G Owners Lounge
4
02-18-2015 03:26 PM
umnitza
Exclusive Sponsored Sales
3
12-01-2014 06:26 PM
PushyTop
Scion xB 1st-Gen Aero & Exterior
22
12-27-2004 02:29 AM