Ok im going for PRNDL lights. i found this light bar

http://superbrightleds.com/specs/LB3.htm

will that fit underneath. and can i strip the current wire where the orange bulb is and somehow stick in those black sockets in the LB3? i want make sure im not makin a mistake. if it w ill be ok then i will make another DIY vid.

THANKS
COME ON LURKERS POST

 

any LED light strip rated for 12V works for the PRNDL lights. jimmbomb and i both used a LED strip that was too long and just cut off the excess. i think we both wired it up the same way, which was to cut off the old light and splice the LED strip in.
hopefully this thread might help:
https://www.scionlife.com/forums/vie...ighlight=prndl

 

tank u

 

yeah I think that will fit in there fine.. I did the 'convert to inches' & it came in at a little over 4 inches.. not quite 4 & a half.. So it should fit...... I am just concerned that it may be TOO BRIGHT for you!!!... let us know.......jh

 

imma do it 2morrow. if its two bright then i just remove an led or put some film over it

 

if it's too bright... turn the strip on it's side or up-sidedown....... get the in-direct light effect..
test it out in different position at night...M..... you'll make a good one, I have faith in the Butterknife modder!!!! jh

 

u stay crackin me up