Since I know I'll never have 3 people in the back of the xD, I thought that having the belt hanging from the roof (even neatly tucked in) is not good enough.

14mm socket, 5 minutes and it disappears:

 

Is there going to be a write up on this? I would like to do this to mine also. I think i could probably figure it out but i would rather know first before i start going to work. Thanks
Bennyboy
O and did you just tuck the belt underneath the plastic liner on the side?

 

1. With a small flat screwdriver open up the plastic seatbelt guide (the one attached to the roof). This will expose the 14mm bolt.

2. Undo and remove the bolt.

3. With the same screwdriver pry out the metal washer that will remain in the plastic trim piece (or leave it there if you don't care).

4. Store the bolt and assorted washers.

5. Gently pry off the trim where the belt goes "inside" the wall of the car, fold the belt and store it underneath the trim.

6. Click the trim back.

7. Enjoy.

 

Thanks bro. Seemed that simple. Just wanted to make sure there wasn't anything tricky about the procedure. I didn't think so considering it only takes 5 minutes. Thanks again
Bennyboy