Replacement windshield wipers
My daugter has an '08 xd and is in need of new wipers. We ordered from the dealer but all we got was the rubber blade. Is this all there is? Does Rainx or any other after market manufacturer make replacement wipers for the xd?
Thanks.
Thanks.
Originally Posted by BuckeyeScion
My daugter has an '08 xd and is in need of new wipers. We ordered from the dealer but all we got was the rubber blade. Is this all there is? Does Rainx or any other after market manufacturer make replacement wipers for the xd?
Thanks.
Thanks.
Aftermarket wipers will also work. They are just general fit though. You will have to get the correct sizes and you'll be ok. Take off the wiper blade when going into the store and ask for that size.
Originally Posted by BuckeyeScion
My daugter has an '08 xd and is in need of new wipers. We ordered from the dealer but all we got was the rubber blade. Is this all there is? Does Rainx or any other after market manufacturer make replacement wipers for the xd?
Thanks.
Thanks.
I'm assuming it is pretty standard... there are two spring-metal blades that go into a groove on either side of the blade insert, then the whole thing slides into the wiper arm. There should be a detent at one end of the rubber insert where the wiper arm grabs it... the detents will be in line with the groove that the spring-metal blades fit into.
Grab the end of the old insert opposite the detents and pull hard. Once it pope out of the detents, it will slide out easily. Note which way the spring-metal wants to curve relative to the windshield. You want to put them back in the same way so that pressure is applied evenly across the blade. Installation is opposite of removal. It helps to have some needle-nose pliers to pull the last little bit onto the detents.
Found a how-to: http://www.expertvillage.com/video/1...ar-inserts.htm
That's a Subaru in the video... they have a clip that you squeeze. I'm not sure how Toyota does it... but you'll get the idea.
Grab the end of the old insert opposite the detents and pull hard. Once it pope out of the detents, it will slide out easily. Note which way the spring-metal wants to curve relative to the windshield. You want to put them back in the same way so that pressure is applied evenly across the blade. Installation is opposite of removal. It helps to have some needle-nose pliers to pull the last little bit onto the detents.
Found a how-to: http://www.expertvillage.com/video/1...ar-inserts.htm
That's a Subaru in the video... they have a clip that you squeeze. I'm not sure how Toyota does it... but you'll get the idea.
Thread
Thread Starter
Forum
Replies
Last Post
hampton1100
Scion tC 2G Suspension & Handling
2
Jan 2, 2015 08:13 PM
KingLou
Scion xA/xB 1st-Gen ICE & Interior
14
Mar 1, 2004 10:37 PM
2007, remove, replace, replacement, scion, size, tc, tv, windsheild, windshield, wiper, wipers, xa, xb, xd







