Hey, this is prob a dumb question but i want to be sure before i go to install... i layed everything out in my room and i got it figured it out except for the power/ground with the metal circle on the end, theres another set of ground/power for the switch and i know how to hook those up, just not the power with the circle on the end, and the power... not sure where they are located... im not 2 sure where these hook up. I didnt take a picture so hopefulyl you guys knwow what im talking about. Thanks guys.

 

if im right i think i know what you're talking about...

do u have a cai or sri? if you have a cai you'll see a bolt there DONT use that for a ground. there will be another bolt to the left of the cai by itself. just unscrew it and hook the ground up and screw it back on.

does that help lol?

 

ya i know i can ground it anywhere...but idn where i do tjhe power that looks like that ya no? cuz like it usually dont have metal circle on end... ground isnt the prob its the power

but i have a CAI...

 

you connect the positive wire to the battery.

or did i miss something?

unless you want to wire it up this way....

battery-> positive wire-> switch-> negative wire from switch ->positive wire of foglight. from foglight: negative wire ->ground.

 

mine was plug and play...

 

i was thinking battery too i wanted to make sure... i think mine is plug and play too i just have to ground and power 2 wires.. not hard just wanted to make sure...

 

His seem like they aren't VRD or OEM fog lights. They are just off the shelf.

If you have to wire it up to the battery it isn't plug - n - play. My VRD's just plugged into an already existing foglight harness that comes with our car, and a ground on one side if I recall.

Then the switch just plugged into another harness in the dash, and voila it worked. I might've missed something but it was a long time ago.


But like I said i'm assuming athlete3232 doesn't have VRD's or OEM add-on fogs.

 

so i hook i it up to the battery, or should i take a piccture 2 be sure?

 

the big red circle are the 2 wires idn where to hook up

 

the circle in the bottom right is to the battery + and -. The other two are weird. it's next to the switch, which is too far from the battery to conenct there. the only thing I can think of, is if it's a lighted switch, and those wires are to make it light up.

 

yeah it is lighted, so its just for that i believe... that wont be a problem. So i hook these up right 2 the damn battery? ____ttt

 

yes, well the positive one anyways. or you can run a small wire from a distrobution block if you've got one from your system. But your most likely puting the switch near the console, so just run a 14ga wire through the firewall and be done. The ground can just use a bolt near the mounting area.

 

ya, everything i need to install is picture right, once i power it and ground it 2 the battery and the switch im good right?

i dont got a ssytem anymore