LED Swap (Steering Wheel Controls)
11-03-2005, 10:31 PM
#1
Senior Member
Music City Scions
SL Member
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: Nashville, TN
Posts: 1,548
LED Swap (Steering Wheel Controls)
Tools Needed:
Philips Screw Driver
Wire Cutters/Knife
T30 Torx Bit
3 LED's (I Used Blue)
1. http://lc-led.com/View/itemNumber/98 - These are for the Guage Cluster, Steering Wheel Controls, and the AC Unit
2. http://lc-led.com/View/itemNumber/38 - These are used in the stock radio
Tweezers
Solder
Soldering Iron
1 Wire Tie
**Probably a good idea to disconnect negative battery cable first**
2006 Scion TC
1) Loosen the 2 T30 Torx Bit screws on either side of the steering Wheel
Left Side (Sorry for poor quality pic the screw is in the hole shown):
Right Side:
2) Gently pull the center section of the steering wheel toward you and prop it in a good postion. This will expose the single screw needed to remove the radio controls from the steering wheel.
3) Remove the screw holding the radio controls in place and then pull the controls out (It takes a pretty good pull to get this out)
4) On the back of the radio controls remove the 3 very small screws(shown highlighted in blue), and also clip the wire tie holding the electrical connection(shown highlighted in green)
5) There are 3 LEDs on the board(highlighted in Blue)
6) Finished Product!
Philips Screw Driver
Wire Cutters/Knife
T30 Torx Bit
3 LED's (I Used Blue)
1. http://lc-led.com/View/itemNumber/98 - These are for the Guage Cluster, Steering Wheel Controls, and the AC Unit
2. http://lc-led.com/View/itemNumber/38 - These are used in the stock radio
Tweezers
Solder
Soldering Iron
1 Wire Tie
**Probably a good idea to disconnect negative battery cable first**
2006 Scion TC
1) Loosen the 2 T30 Torx Bit screws on either side of the steering Wheel
Left Side (Sorry for poor quality pic the screw is in the hole shown):
Right Side:
2) Gently pull the center section of the steering wheel toward you and prop it in a good postion. This will expose the single screw needed to remove the radio controls from the steering wheel.
3) Remove the screw holding the radio controls in place and then pull the controls out (It takes a pretty good pull to get this out)
4) On the back of the radio controls remove the 3 very small screws(shown highlighted in blue), and also clip the wire tie holding the electrical connection(shown highlighted in green)
5) There are 3 LEDs on the board(highlighted in Blue)
6) Finished Product!
01-12-2006, 06:12 PM
#7
Senior Member
SL Member
Join Date: Sep 2005
Location: New York
Posts: 246
Originally Posted by IAmTheProdigy
Probably a ridiculous question, but when removing center section of the steering wheel, are there any precautions in regards to the airbag? I think not, but I just want to verify. Thanks.
01-14-2006, 02:01 PM
#10
Senior Member
Music City Scions
SL Member
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: Nashville, TN
Posts: 1,548
Originally Posted by scioncraze05
are the leds the same as the gauge cluster and center console???
