Hey everyone - i just installed my exhaust today, sounds great, but i am curious as to the one extra hanger is for. the stock obviously uses 3 rubber pieces to connect to the hanger, one on the left, one on the right, and one in the middle towards where you bolt on.

I used two out of the three rubber pieces, but there isnt anything to connect to the far left side hanger, only the middle and right. There is a spot for another hanger on the exhaust but no where to connect it on the car, where does this go?

 

http://www.injen.com/galleries/produ...directions.pdf

another hanger is locate in the middle.

 

hmmm it ends up that i dont have the hanger bracket...i will have to make one myself i guess!

 

Here's the piece of info that will help you close this case....
I've had the Injen Super SES exhaust on both of my tC's. Back in 06-07 Injen changed the design ever so slightly by adding an additional hanger mounting point on this exhaust for the Scion tC. It gives a little extra support I'd say it's safe to assume. However, I've never had ANY issues with the one I have on my 06 and 08 tC's that don't have the additionally added hanger mounting point. And the one on my 06 has been perfect for over 60K miles since I installed it on that one.
Hope that helps.

 

contact injen, they will send you a bracket.

 

can u post a pic of ur exhaust? Also i wanna know if injen changed the tip design. i could have sworn i saw a pic on here before but i cant find it.

 

thanks for the input everyone, i contacted injen about an extra bracket although im sure it would be equally as easy to make my own bracket. The exhaust sounds great and im sure I wont have any problems with only using the hangers i have now, but I would like to get that last one on there for piece of mind!