View Full Version : Factory audio wiring


noisy1eh
11-29-2010, 11:16 PM
Help
I need to know if the factory head unit has a external amp?
Also need the wiring dir for the audio system for i have a Kenwood DNX9960 and need to install it in the wife's car for xmas.

1stOne
11-29-2010, 11:48 PM
Yes, there is a factory amp. You need to wire the remote turn on wire from the aftermarket radio to the power antenna wire for the Metra harness (or equivalent).

Besides that, everything else wires direct. So speakers to speakers, power to power, ground to ground, etc.

noisy1eh
11-30-2010, 11:51 AM
I didn't know that a metra wiring kit was out for the 2011 TC??
Thanks i will look again.

bigboi18184
06-22-2011, 08:30 PM
Sorry to bring up an old thread for my first post but I'm trying to find out what color the wire is for the remote turn on for the factory amp is. I know for its usually blue but wanted to be sure before i take the dash apart.

Just got me the new 2011 TC and have read that without this being wired up with my aftermarket deck the 6.5" in the front doors will not work.

KidJustin
06-22-2011, 09:47 PM
blue

bigboi18184
06-22-2011, 10:07 PM
Alright just making sure, i knew the aftermarket wiring harnesses were most of the time blue for the remote. Was just making sure scion didn't make it some odd color.

thx for the reply

op4dc4
12-06-2011, 12:59 AM
Hi everybody I want to know what connection you make for the 6x9 woofer .Iknow its the blue on the metra wiring but on the oem harness its which color and which plug because there is 4 of them .thanks a lot .

RedDragons
12-06-2011, 10:20 PM
70-1761 is the metra part #. Pretty much every toyota made vehicle since 87 uses it unless it was factory amplified 1992 and up. But even some of the amplified toyotas still use the 1761. Here are the wires:

Radio 12V
blue+radio, white 10 pin plug, pin 4
Radio Ground
brown-radio, white 10 pin plug, pin 7
Radio Ignition
yellow+radio, white 10 pin plug, pin 3
Radio Illumination
gray (parking lights); blue (dimmer)+,-radio, white 10 pin plug, pin 10; white 6 pin plug, pin 5
Factory Amp Turn-on
white (woofer amplifier)+radio, white 10 pin plug, pin 9
Power Antenna
red+radio, white 10 pin plug, pin 8
Left Front Speaker (+/-)
pink - purple (mid-range and tweeter)+,-radio, white 10 pin plug, pins 2 and 6
Right Front Speaker (+/-)
lt. green - blue (mid-range and tweeter)+,-radio, white 10 pin plug, pins 1 and 5
Left Rear Speaker (+/-)
black - yellow+,-radio, white 6 pin plug, pins 2 and 6
Right Rear Speaker (+/-)
red - white+,-radio, white 6 pin plug, pins 1 and 3
Center Channel (+/-)N/A
http://www.directechs.com/Images/spacer.gifhttp://www.directechs.com/Images/spacer.gifSubwoofer (+/-)
woofer amplifier uses LF and RF for preamp inputhttp://www.directechs.com/Images/spacer.gifhttp://www.directechs.com/Images/spacer.gif
Aux. Audio Input Left (+/-)
white - black+,-radio, white 20 pin plug, pins 17 and 16
Aux. Audio Input Right (+/-)
red - black+,-radio, white 20 pin plug, pins 15 and 16

Notes: The woofer speaker wires are yellow - black (LF); red - white (RF) at the woofer amplifier, white 10 pin plug, pins 1 and 5; 2 and 6. The woofer amplifier is under the driver seat.

dm1336
12-06-2011, 11:20 PM
If you get the above metra part harness you can just plug it into the harness behind the radio since everything lines up correctly to the right pin.

The 6pin plug is for the rear speakers and the 10pin is the main one. You need both of those in order for it to work. The plugs on the other side is for steering wheel control and avc-lan

The 6x9's won't work unless the amp under the drivers seat is powered on.

This wire handles that:
white (woofer amplifier)+radio, white 10 pin plug, pin 9
This wire is blue on the aftermarket harness and decks.

RedDragons
12-07-2011, 12:13 AM
And the solid blue metra wire will also power the antenna amplifier. There will be loops going to 2 or 3 different pins on the harness.

op4dc4
12-07-2011, 03:23 AM
thansk a lot guys I made it have a nice day everybody.