I have 2 12" Rockford Fosgate P14S12 4 ohm Subs and a RF 400W 2 Channel Amp. I also have a Alpine Dual 12" Sealed Sub Box.

I am looking for some guidance on how to wire the Subs in the box and exactly how to wire them to the preexisting connectors on the either side of the box.


Would this wiring work?

http://www.rockfordfosgate.com/rftec...hmSVC_2ohm.png

 

Both Subs are SVC, anybody have any advice?

 

if tis a single ported box yes. if not and is a split dual port box run 2 wires for each positive and negative for each sub. you will get the same effect