I had my front bumper replaced back in the spring and it looked great until recently it started sagging and the lines of where it meets the fender look really bad (see pis below). I can push it back in by hand, but it just pops back out a few days later. Is there a way to adjust this to fit better? I have never taken the bumper off before so please keep that in mind.

 

that part of the bumper usually just pops in the tabs on the headlight. can you look to see if the headlight tabs are cracked???

 

Either cracked tabs or it's sitting below where it's supposed to clip in. Same happened to me.

 

I just noticed the same thing with mine yesterday. I think I missed the tab on the headlight cause only the passenger side is sagging.

 

get a buddy.
take it off.
put it back on.

just make sure you line everything up properly.

 

Make sure you tighten everything down.

I know a guy who let someone else work on his tC, he didn't tighten everything because he didn't care and the owner was driving on the freeway and had his whole fender lining and splashguards rip off and fly away.

 

Are you offering your services???

 

lol!

 

didnt realize he was local.
ill help, its really not that hard to do though...

 

not hard at all. I noticed he is up in Palatine. G.E. is a little closer then Naperville (not much)

 

yea, a lil closer.
you shoulda came to Nebs this weekends Scott.

 

Yeah, I had that problem with mine for the longest time. There is a clip thing under the headlight. Make sure it is in there correctly and it should fix it.

 

i had no time too

worked friday, wedding Saturday, worked all day sunday and monday

 

busy man.
maybe next time.

 

who all went?
how's nebs car looking?

 

me and my buddy fil stopped by "on our way" home from NIU.
its looking good, coming together slowly, but sexy nonetheless.

 

Thanks for the help. Ill try to get this fixed following the directions

 

I've seen this on a few cars before. Just check all your tabs and screws