How is everyone stripping the O2 sensors???
#1
How is everyone stripping the O2 sensors???
I keep reading threads about how everyone is stripping the O2 sensors when they install a header.
I had no problem when I put on my MMW. I used a pipe wrench to loosen the sensors and they screwed right into the new header/S-pipe no problem.
I just dont get it....
I had no problem when I put on my MMW. I used a pipe wrench to loosen the sensors and they screwed right into the new header/S-pipe no problem.
I just dont get it....
#2
its a soft metal and hard to put in properly and in my case i didnt notice the megan header i had since it was used had messed up threads and mush went the threads on my o2 lol but its all good i fixed it now didnt cost a dime
Thread
Thread Starter
Forum
Replies
Last Post
anurok
Scion tC 1G Drivetrain & Power
9
12-21-2006 03:03 PM