New clutch master cylinder help
#1
New clutch master cylinder help
Hello,
I have 2010 Scion tC that I had clutch pedal getting stuck against the floor. Had to use my foot to lift the pedal back up. Searching here the forums I went ahead and ordered master cylinder. Went ahead replaced it with an autozone brand, installed and bled the lines. My problem is my clutch pedal just drops to the floor, tried adjusting the rod rotating clockwise. It just comes apart, from the connector piece that links to the pedal arm. I bled by pumping the pedal few tims still the same.
Thank you in advance you guys
I have 2010 Scion tC that I had clutch pedal getting stuck against the floor. Had to use my foot to lift the pedal back up. Searching here the forums I went ahead and ordered master cylinder. Went ahead replaced it with an autozone brand, installed and bled the lines. My problem is my clutch pedal just drops to the floor, tried adjusting the rod rotating clockwise. It just comes apart, from the connector piece that links to the pedal arm. I bled by pumping the pedal few tims still the same.
Thank you in advance you guys
Thread
Thread Starter
Forum
Replies
Last Post
ScionLife Editor
Scion iA Discussion Lounge
0
03-18-2015 05:40 PM
foxSCION
Scion xA/xB 1st-Gen Wheel & Tire
13
12-03-2003 05:40 AM