As some of you may know, I'm a Nissan tech, so I'm familiar with Nissans only. I might be doing a clutch on a pre-owned "05 tC with about 41K miles on it. Since I drive a Scion xB, my boss felt it should go to me...
Simple question...will it be easy to replace and how long should it take me? Don't forget, I have access to a car lift and power tools...

Thanks guys!

 

is the nissan engine in the same place like toyota engine?
Does it have 4 wheels also??
Oh what is nissan??
So many differences

 

dang that was pretty harsh ...

its an all day job for techs . so if you go the same tools and experience . take a day off work and get r done.

 

Its not that bad, trust me. My boy did a clutch/flywheel on my 3000gt and it took bout 3 hours to do. And a 3000gt is much harder then a TC. Simple...

 

TC's engine bays are very open if u kno how to do frnt wheel drives ur finne

 

you as a tech should do fine, might take just a bit first time.. but with all the tools you have.. it should take just like a regular nissan clutch install

 

I looked at the tC again and Yup!...looks fairly easy! Also, I looked on Alldatapro.com and it says that the labor for the clutch is almost 7 hours! I'll find out more on Monday when I get back to work...