Not getting any spark, or rpm signal when computer is on, but everything else works

 

cam position sensor might need replacing.

 

well, if i have the stock ecu hooked up by itself, it gets fuel and spark and trys to start, but the 1200s pump to much fuel

 

what do you mean everything else works when you are not getting any sparks or rpms signals? like the car starts and runs fine but doesnt show anything when you hook up the laptop?

 

the car wont get fuel or spark and shows no rpm signal when the laptop is connected, tps and everything work though,

 

if the stock ecu is connected by itself it gets fuel and spark
and i just got a 07 pnp harness from hydra
so im wondering if theres a setting in need to change

 

where did you get your basemap? like nothing happens at all when you crank? your trigger settings may not be configured right.

 

the map was off of my friends tc, which has pretty much everything i have except a gt42. id like to get a fresh map

 

what should the settings be?

 

that map worked before or not? did you get your hydra unit from your friend as well? on hydra you cant just swap maps, that could lock out your unit

 

the map did work before

 

just take it to a tuner that is familiar with hydra.. so they can communicate with tech support. There are tons of configurations you need to look at, if you are not familiar with tuning you might just mess it up some more..

if its a hydra 2.5 version you can email me your map, ill try to see if I see something wrong.

 

You must push the PINS closer to the cam sensor and the brian crower cams. The distance is to large and can not be picked up, the oem ecu does not need cam signal to run!

 

Cams?

 

Mike is spot on here. Dowel pins are the key.

 

do what mike said that could be your fix

 

turns out hydra repinned their new harness, so i had to switch a couple of pins around

 

did it work now?

 

yeah its working now, and now cylinder 4 injector isnt wanting to work

 

whats your email