Well I got board and it's dark out, so I decided to post up my lights

General Info:

Canter Map Light is a 6x6 square of 5mm leds 36 total
Other Map Lights are high intensity white ones
Rear over head light is a 3x3 square of smaller leds

Accent floor lights are a 48 led strip with a 3mm led every 1cm (one per side)
Cubby hole and air vent lights are 5mm leds with chrome holders
These light turn on when I turn on the parking lights

Hatch light is another 6x6 square to light up the subs
The ports are also lit up by a 48 led strip for each port
These light come on when the hatch is opened

Main Interior:













Here is with the flash to show the setup:






Cubby Hole:
(yes I know it doesn't look anything like yours does)







Also w/ flash

the switch you see will turn all the floor lights and cubby hole lights off if needed



A/C vents:





Overhead lights:







Hatch light:
A little hard to see...



w/ flash



And last but not least, Sub box ports:




Tha camera makes them seem not that bright, but trust me they are very bright (just compare them to the gauge lights)
I hope you like them and shoot me any questions you may have

 

*want* Where did you get the footwell lights?

 

I gotta get off my butt and install my vent lights and love the lights under the cubby......

 

I got the foot well light from here:

http://www.besthongkong.com/index.php?cPath=10_59

They are the 48 cm ones which comes out to be about 19 inches or so,
the fit perfectly under there stretching from one side all the way to the next with an led every cm for a perfectly uniform light

the only thing about the website is that shipping takes anywhere from 2-4 weeks cause the package has to come through customs, I've ordered from them a few times.

 

You could always go to oznium.com Great products and very fast shipping.

 

Oznium FTW

 

x2

nice set up man, I love the hatch light

 

nice job! it like the ac vents.

 

Nice. I like the cubby idea but too blue for me.

 

Looks great. I'm actually doing much of the same this weekend. Good to see what I'll be doing haha.

 

Although this was placed in a '09 Camry SE, this will work in any car

It was simply plug and play. It works with any car that uses 194/921 bulbs. In the process of making them work in 3022/3175 festoon bulbs. Just need to order parts. I have some laying around if anyone is interested.






I also soldered a fuse holder and added a slow burn fuse. The inverter I have pictured is the cheap one where if you plug it in the wrong way, it will blow out the slow burn fuse as well as the inverter. The ones I have laying around have built-in reverse polarity. So if you plug it in the wrong way and it doesnt work, just flip the plug around. No need to replace fuse or inverter.