I was wondering if the MTX Thunder 2301 Amp will work with the ED Stealth Enclosure.
Thanks

My Amp:

http://www.crutchfield.com/App/Produ...115&tab=review

EQ Sub Enclosure:
http://www.edesignaudio.com/edv2/pro...roducts_id=465

 

rdub09 that amp should work fine but you wont be using the sub to its full potential .. that amp can only out put 150rms where as the sub can handle 300rms

so if your looking to get the most out of the sub i would look into a different amp...
i too was wonder what a good amp for the Ed stealth box would be... and also how many Voice Coils should i get it with, 2 or 4?

so does anyone have any good suggestions for us?

 

That amp has plenty of power for the sq10. You can get a 2ohm voice coil sub, and the amp will put out 300 watts at 2ohms. I was using a MTX amp to run my stealthbox(I have upgraded to a 5 channel since), I'm not sure how much power the MTX was putting out, but it is a very small amp and the speaker would clip if the volume was too high.

 

Not attempting to threadjack here....but I'm really considering this sub.....how's it sound, cause I'm tryin to go for a stealth setup....thanks *end thread jack*

 

i had one a while back. great SQ, but doesn't get too loud. i forget who it was that created his own box and ran 2 of them, but thats what i suggest. one wasn't nearly loud enough for me.

 

I agree with exige, I'm still waiting for ed to come out with a dual box. There have been posts of people getting more output using different brands of shallow mount subs in the ed box, so you can go that route too.

 

yes your amp will work perfectly with that 2 Ohm set up to answer the original question