Took off my Door Panels. Oh man it's riveted in. PICS!!
#1
Took off my Door Panels. Oh man it's riveted in. PICS!!
I decided to attempt to take off the door panel. Man it was easy. I am taking pics as i go. I am uploading some now.
I'll resize them later. Now does anyone know what we can do about the rivots? I will see what i can do.
I'll resize them later. Now does anyone know what we can do about the rivots? I will see what i can do.
#5
Same setup as on the Matrix - what we used to do is dremel out the old cone from the speaker housing (leaving the black riveted part in), and then just screw the new speakers to the plastic housing (using the housing as a spacer).
#7
Yea i was just outside and it looks like a _____. If u gut out the old speaker theres not much to screw the new speaker too. I can't believe they riveted them in like that. Very dumb.
#11
Replacing them is easy.
Just drill the center of the rivets out, and they come right off. Reattach with some screws.
I already put a whole system in my tC. What a difference. The factory stuff is so bad.
Just drill the center of the rivets out, and they come right off. Reattach with some screws.
I already put a whole system in my tC. What a difference. The factory stuff is so bad.
#13
Originally Posted by Nick@AGP
Replacing them is easy.
Just drill the center of the rivets out, and they come right off. Reattach with some screws.
I already put a whole system in my tC. What a difference. The factory stuff is so bad.
Just drill the center of the rivets out, and they come right off. Reattach with some screws.
I already put a whole system in my tC. What a difference. The factory stuff is so bad.
Thread
Thread Starter
Forum
Replies
Last Post