warming up your car
yea also when the tc isnt warmed up, u can practically just let off clutch with no gas if u wanna drive slow since the rpm is a bit high, which is cool, unless im the only one that can do this lol
Originally Posted by KeRoLiUkAs
Originally Posted by GammaTNT
too bad my stick tc, can't install remote start
I was under the impression that as soon as the engine turns over, you have oil pressure. Meaning you can drive safely.
But like others have said, just don't race/redline the engine before it's fully warmed up.
But like others have said, just don't race/redline the engine before it's fully warmed up.
Originally Posted by Clipdat
I was under the impression that as soon as the engine turns over, you have oil pressure. Meaning you can drive safely.
But like others have said, just don't race/redline the engine before it's fully warmed up.
But like others have said, just don't race/redline the engine before it's fully warmed up.
Flow, give it a minute.
Let the fluids circulate and get to the moving parts.
Then go, but take it easy until it's warmed up on the gauge.
Don't know enough about SC to know if it makes a diff.
I think any car should run at least 30 seconds to let the fluids circulate.
I've been doing it for over 35 years, and never had an engine problem.
I think any car should run at least 30 seconds to let the fluids circulate.
I've been doing it for over 35 years, and never had an engine problem.
Where i live, you never know. Somedays its so cold that I need to remote start it from across the street (from my apartment), and let it sit for about 5 min. Other days its so warm I just get in, turn it on, put the seat belt on, change the song on the headunit, and then throw it into 1st, start rolling.
Usually, it depends on the weather. These guys have it down right, wait a couple min, for fluid/oil movement and idle set (about 750-1K RPM).
Hope this helps.
Usually, it depends on the weather. These guys have it down right, wait a couple min, for fluid/oil movement and idle set (about 750-1K RPM).
Hope this helps.





