_NeXuS_

Well I want to push my wheels out a bit, ive read 8mm is the max you can push the stockies. Since the Super 7's use the OEM lugs 8mm would be the max too right?? Any problems if I run wheel spacers??

I read that Kics is a good brand, so are these spacers in the link good?
http://cgi.ebay.com/ebaymotors/PROJE...Q5fAccessories

DJ08tC

8mm is not just for stock wheels, 8mm is for the stock studs, any further you are suppose to get extended studs.

_NeXuS_

Ahh I see then im good with the ones I listed?? Or will I need anything else? I read you need hub centric ring. But thats when you get extended studs right?

DJ08tC

you get the extended studs because anything over 8mm will push the wheel out to far and there will not be enough threads to properly tighten the lug nuts to

RusWolf

iTrader: (3)

i run 5mm spacers that help me clear my wilwoods and there has been no problems with them that i have noticed and in my opinion it looked almost flush and pretty good.

_NeXuS_

Awesome

So I dont need hubcentric rings??

Just get the 8mm I listed and im good to go?

RusWolf

iTrader: (3)

i'm not sure about 8 my friend, i can only vouch for 5 mm.

_NeXuS_

Hmmm alright. Can someone confirm if I need with 8mm?

dqlostsoulz

iTrader: (3)

I have ran 8mm with no problems just torq them down.

_NeXuS_

What do you mean by torq them down?

Just take off the wheel and slap the spacer and put the wheel back on right...

dqlostsoulz

iTrader: (3)

yeah. Just tighten them more often to be on the safe side.

_NeXuS_

Ohh I get it just retight my stock lugs often when I run the spacers right?

dqlostsoulz

iTrader: (3)

yeah use a torq wrench and torq it down to 75ft/lb

_NeXuS_

I dont have a torque wrench tho :\

dqlostsoulz

iTrader: (3)

you can get one at harbor fright for like 20 bucks...
http://www.harborfreight.com/cpi/cta...Itemnumber=239

I have that one and also the 3/8

greenbean24

iTrader: (1)

Harbor freight FTW..... I love that place

_NeXuS_

Thanks man! So I should get the torque wrench before getting the spacers huh...

DJ08tC

to properly torque down your wheels yes,

thekevin

iTrader: (3)

don't cheap out on a torque wrench.