Oh yeah thanks for the pics too, dm1336. I had managed to do mine before I read your post, but those are definitely going to help lots of people avoid breaking anything when they pull the panel up.

 

Yea your welcome. I just need to figure out why the images are all upside down on my iPhone but look fine on desktop. Damn Imageshack

 

Haha weird man I'm on an android phone and they look fine.

 

Nice, I was wondering how to fix that.

 

I thoroughly examined everything in door panel, my rattle is caused by the plastic that is wrapped inside of the door, air vibration going in and out of the hole in the plastic where the wires go causes it go flap flap flap, causing weird noises. i realized this when i spent an hour double side taping/silicone/ etc on the little plastic piece with window up and down switch. then it was out and i still heard it..

its the plastic, i taped it down etc and made excess flapping stop. it reduced it, but not 100%. im going to dynomat my entire door to see if this helps.

 

Ok, Ok. So after reading this thread I said, "I can do this...super easy." I attempted to pop up the panel and it came up a little bit. After trying to go further, it seemed like it would budge so I said..."another day" lol My only problem is that NOW, towards the top side where the handle meets didn't snap back all the way in and its small gap now....and now matter how hard i push in...it aint going back in. What do i do? I dont know if the 2013 is different from 2012.

 

pull harder...

 

Honestly, this doesnt quite help. I dont know mb I did it wrong, but I was playin around today and everything I did, didnt work at all =(