So I got a misfire on cylinders one and two (p0301 and po302). When I removed the coilpacks I found cracks and rust along with fluid in the coilpacks. I assume this bad and dont want to even attempt to take out the fouled plugs unless I can remove the fluid.Ii dont have many tools at home so I was wondering what any of you have done in the past to take out the fluid. Any insight is appreciated I have been a long time lurker but finally joined up, if someone could even point me to a thread I may have not seen much appreciated...

 

paper towels shoved down the holes can get the water out. just make the towels come out too.

 

Compressed air to shoot out fluid. Is it oil or water? And do you have the plastic cover installed on top of motor?