hello ive searched quite a bit and either im typing the wrong search words or i just havent found what i need to know.... i need to know which wire i use as the staus output wire. so i can bypass my clutch. i see a wire in the diagram that says status output but it is connected in a harness of wires. Do i splice into that or ???

also there is a wire on my main 12 pin harness that says
(-) remote start activation input... is that used at all? if so where do i connect it?

thanks so much to anyone who can help me out.
Happy Holidays

 

there should be two status outputs on the unit. One of them is on the same harness as the brake wire, and the other one is a separate plug that goes into the relay pack with the large ignition harnesses.