Here's some good pics of the new fogs. A lot better than the other one at least!

 

Those look so much better than the factory fogs...I have been thinking about what lights would work in the lower grilles....thanks for the info!

 

It looks like you're so close to that curb! It's like fingernails on a chalk board.

 

well i did my install last night and it went really smooth. no problems at all. i got the Blazer all weather fogs, which have a clear lens and yellow blue tint on the inside of the lens. when i turned them on they were bright yellow. ill try to get pics up soon. other than my monster **** shift ****, this is my favorite mod so far

 

has anyone tried or had a need to put weatherstripping between the lens and black housing since they are close to the ground.

I dont want water to get in there or for it to be foggy in the lens so I thought that the same sealant that goes into headlight housings might work aswell.

any thoughts

 

Hey midge, have you had any water problems with your Injen and the fog cutouts? I really like the look, but I don't like hydrolock.
/threadjack

 

you won't hydrolock your motor unless the intake inlet is submerged in water

 

^^ That's what I thought. I was just being paranoid.

 

I live in Utah and have gone through some pretty major storms. I have never had any problems. That's what your filter is for. If you are that paranoid about it you can buy a "sock" or a bypass valve and that should take care of your worries. The intake sits a little bit above where the holes are, so I don't think I would get that much water, if any, up there. Plus I added the mesh to the holes, which I think helps to deflect some of the water.

 

Cool, thanks.

 

Just a quick question. How do I pop the switch cover off the console??

 

The blanks? I just reached around from the back and pushed. They aren't in there that tight. A small suction cup from the front might work too.

 

Or you can just take the center part of the dash off. It's super easy. There's only 2 screws and it just pops off.

 

and where the 2 screws locate at?? It will be much easier if I can take that thing off.

thanks

 

There behind the ***** for the a/c. Just pop all 3 off and you'll see the 2 screws. Then just pull from the top of the center part of the dash. Once you get it off there are 3 connectors that you will have to disconnect. It's super easy!

 

i didn't have to take any of the dash apart, just used a tiny flat head and it popped right out with no scratches.

 

awww so i'm no longer going to be the only one in Elk Grove with this mod?

 

that is true. you are going to see a white box with those lights on soon.

 

hey your liscense plate isn't LOWRATT is it?

 

no, thats not me...were you talking about the one with camber wheels? i saw that once b4 near the bel-air area..it was NICE