Had anyone installed this factory alarm system? What sensitivity level do you set yours at? I left it at level 5 just like what it says on the manual and it seems like it's not trigerring the alarm

i would raise the sensitivity but i dont wanna move all those panels again... is it something wrong with my alarm or do i just need to raise the sensitivity?

 

i would suggest moving it to 7.

 

raised to level 8 and it works!!!

 

The higher the number more sensitive it is??

 

is the sensitivity **** easy to get to?

 

yea, higher number is more sensitive. to get to the ****, u have to open the shiftknb dash and remove that sensitivity comp and use small flathead screwdriver to adjust

 

is any of this in the manual that comes with it?

 

no, but you can get the installation manual from trdsparks.com

 

sounds good..i just did the test...tappin on the window in the middle...and nothin...and i was tappin pretty good :p

 

wait..im lookin at the instructions...and is this controll module on the drivers side?

 

the insturction said to install it next to the shifter.. try tapping on the passenger side too. it's lot more sensitive on the passenger side than the drivers side due to the steering wheel column and the shifter

 

yeah...i was tapping harder than i wanted to and it still wasnt going off..i will adjust it later on this week...thanks for this...i wouldnt have known otherwise...i never really read the whole manual...