Installing LEDS
I am installing a LED underbody kit tomorrow on my box. At the front there is a plastic cover under the engine how have you guys with under car light gotten around this?? take it off or cut it or is there another way??
Thanks
J~
Thanks
J~
After lowering the box, I didn't want the lights hanging under the splash guard, so I removed my splash guard, drill several holes and mounted my LED UnderGlow Tube to the bottom of the radiator mount. Works great!
XBinRochester Thats exactly what I was thinking I didnt want the tube to be visible(Hate that) I was thinking about removing it. Does removing it cause you engine compartment to get and noticeable dirtier or anything??
I took mine off, laid out where the tube would be, cut out that section, and put it back after mounting the tube. I've seen too many people break their front tube with it mounted below the splash guard, especially if lowered.
XBinRochester Thats exactly what I was thinking I didnt want the tube to be visible(Hate that) I was thinking about removing it. Does removing it cause you engine compartment to get and noticeable dirtier or anything??
I have them mounted along side of the Pinch Welds. The brackets that came with them made them hang down way too low, so I modified the brackets so they are as high as possible. The only problem I have now is that I have to remove the tubes when the car has to go up on a lift, since most service lifts use the pinch welds and the tubes hang down lower than them. I will try to take a picture of the side tubes and the modified brackets.
Thread
Thread Starter
Forum
Replies
Last Post
randomsuper
Scion xB 2nd-Gen Aero & Exterior
20
Jun 13, 2015 10:56 AM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
Dec 2, 2003 04:53 PM






