I just bought a Glowshift oil pressure gauge,it came with a oil pressure sensor attachment,and it says its a 1/8 -20 thread size. I'm wondering
if I could use this sensor \ where the stock sensor was? Would I need any other attachments? I have a N/A tC, and all I want to do is monitor my pressure.

Has anyone have bad experience with the Glowshift Oil Pressure Sensor, if not did it screw on to the engine block?

___

 

buy the glowshift filter sandwich adapter, literally doesnt get any easier

http://www.glowshiftdirect.com/Oil-F...-Adapters.aspx

 

or you could go to the local auto parts store and get a "street tee"...like $5 at most...it'll screw in where the the stock sensor is and get u 2 ports...1 for stock sensor and one for the new oil psi sensor...i had an oil filter adapter before i did this and it leaked...not horribly but it still did a bit...

 

^^^save yourself the money and do it like this plus less leakage headaches

 

^x(however many now) get the t. i had a 3 T, so not technically a T any more, but i had it going to my oil feed, stock dummy sensor and oil pressure sensor. no leaks, but then i got a new oil pressure sensor and it wouldn't fit. so i got a prosport sand. adapt. and i went through about 4 quarts of oil leaking in close to 2 months. i now have a greddy adapt. i'm installing today though ^^

Long story short. Go with the T.

 

Is this for a tC1 or tC2?

___