I want to run my fi/c without clamping my maf, I have a modded injen maf holder which seems to be causing problems with the voltage readings. I was running my kit on 7psi with no fuel managment and it was running good af's across the board. Can I enter 0 in all the charts and set a max voltage of 5.05 volts ? will having no values set cause problems ?

 

I'm not expert but I was under the impression that having a map with all 0's just means the fi/c passes through the signal without modifying it.

 

As long as u have it set to percent mode rather than voltage mode yes u can have all 0's entered and it will just pass through

 

^ do you still have to set a max voltage ?