Petem

im going to be pulling the engine within the next 2 weeks... ..... what the best way to get it out of the TC... should the subframe be dropped with eng and trans all together.. or do it with a cherry picker..? i was looking to see how toyota recommends but i have found nothing.?


thanks for any opnions you guys can offer..

davedavetC

iTrader: (4)

probably with cherry picker. unless you have access to a lift and can just get the engine loose and lift the car up?

scandalous

We cherry-picked:

CarbonXe

iTrader: (1)

You're supposed to drop the subframe.

engifineer

That is probably the recommended method from Toyota (it is on most FWD cars these days). However, if I were doing it in my garage, I would use a cherry picker. Especially since I dont have easy access to a lift like I did when I lived in OK where my dads shop is It looks like it should come out ok with a crane, and the above pic shows that it will.

davedavetC

iTrader: (4)

well the last time i pulled an engine i used a cherry picker (V6 Avalon, i think it was a late 90s model) came out fine.

SeanJohn

just make sure everything is dissconnected and out of the way. should be fine.

BZinn1

Man I looked at it and cherry picker is they easiest way to get her out........pull the hood and disconnect..........only if you have a lift should you try to drop it all as you need like 3 feet clearance from ground.........and one hell of a stand to mount it on.......

Petem

WOW.. thanks.. that pic looks like the front end has to come off.. i guess ill do the cherry picker and remove the front ...... thanks guys...

davedavetC

iTrader: (4)

the radiator support does not have to come off, it makes life easier i guess but not necessary.