Rear bumper mount + roll???

Reply Subscribe

Thread Tools

Search this Thread

Oct 8, 2009 | 05:23 PM

#21

David616

Senior Member

SL Member

iTrader: (1)

Joined: May 2005

Posts: 694

From: LOW-WEEZY-ANA

Can you guys post up pictures of how you modified it?

Oct 9, 2009 | 03:18 AM

#22

davedavetC

Senior Member

SL Member

iTrader: (4)

Joined: May 2005

Posts: 20,410

i drilled a hole straight through and held the zip tie in.... that is after i dremeled/rolled/hammered the bumper support bolt hole off

May 25, 2010 | 06:21 AM

#23

kileil

Senior Member

SL Member

Joined: Aug 2004

Posts: 852

From: Scottsdale, AZ

back from teh dead!

So i've already rolled the rear fenders, dremel'ed about 3/8" off the inside of the bumper plastic, removed the 10mm bolts, but i'm still rubbing on something back there. Do i need to hammer the metal tabs that sit about 90 degrees to the ground straight up?

all this because hankook evo v12 225/35/r19's are about 1" wider than falken azenis st-115's of the same spec...