Tach not working after Cruise install
#1
Tach not working after Cruise install
I picked up my RS3 on Tuesday and Friday was the first chance I had to install the mods I have purchase. The only things I did this weekend were install TDR springs and the Rostra RF Cruise Control. I installed both before I test-drove the box. I had the battery disconnected for about 15 minutes while I made the connections for the cruise.
Along with the non-functioning tach, I also have the VSC and Trac Off lights illuminated. I have searched this site but could not find anything about the tachometer not working. After reading every post on these lights being on and resetting of the ECU I am at a loss. I attempted to reset the unit by pulling the negative cable off the battery. Left it off for 30 minutes. No other mods have been installed; Check Engine and ABS are NOT illuminated.
Cruise works properly.
Help, anybody!
Along with the non-functioning tach, I also have the VSC and Trac Off lights illuminated. I have searched this site but could not find anything about the tachometer not working. After reading every post on these lights being on and resetting of the ECU I am at a loss. I attempted to reset the unit by pulling the negative cable off the battery. Left it off for 30 minutes. No other mods have been installed; Check Engine and ABS are NOT illuminated.
Cruise works properly.
Help, anybody!
#2
Hey I have no idea what your problem could be, but I did notice you are from Lincoln University, PA. My bro lives there and is a killer mechanic. Andy's Auto Tech (610) 268-8806. Tell him Rob sent you...BTW, I will be up there at the end of the month. Maybe I will see you around...
Thread
Thread Starter
Forum
Replies
Last Post
Beesh
Scion xA/xB 1st-Gen ICE & Interior
3
01-09-2015 06:30 PM
OTOC
Regional - Pacific Northwest
0
01-02-2015 11:05 PM
TheRedBox
Scion xA/xB 1st-Gen Drivetrain & Power
31
12-02-2003 04:53 PM