JaN_MiChAeL_07

heres minez .... all white LED's, Interior and License Plate

babyfac3pn01

thanks SquallLHeart

Iride_xB04

Its pretty simple, i put in green in my boxs overhead

hawgs74

Anyone know if these will fit in our Dome?

921-x12 Wedge Base LED bulb
921 Type with 12 LEDs, replaces 194/168/912 wedge base car bulbs
Wide 100 degree beam pattern, non-polarized
measures 1.20 inch long by 0.60 inch diameter
http://www.superbrightleds.com/cgi-b...6.2346&next=50

sorry if its been asked but dont have time to search 10 pgs of thread.

R2D2

Mod'n Bulbs = prerequisite to any car mod.

imsonofagun

I have the 9-LED 921 bulbs in my front dome right now. They work pretty good. They do stick out a little more, which puts them real close to the cover for the dome lights. As long as the 12-LED ones aren't much longer than the 9-LED ones, you'll be fine.

im4degreesaboveu

so i just did the dome swap to mine and have read this a few times and the general complaint is that it is sometimes hard to get the bulbs out. i used two pieces of duck tape and pulled them out with no resistance. since you will not be using the bulbs anymore why not, right. just thought that might help some of you out

koolestkutta

Do any of you ride with your interior lights on? If so, have you been pulled over?

NADroj20

does anyone know if the 9led will work instead of the 6 led in the front dome? and will the 9 led work in the license plate lights?

DriveEuro

Yes it will. I've used 9 led and 12 led in my front dome. Both work fine.

And the bulbs that have LEDs facing sideways are better for your license plate lights.

NADroj20

do u have a link for the sideways leds?

DriveEuro

http://www.superbrightleds.com/cgi-b....16718&next=50

9th one down. I have those in my license plate lights and they works great.

crazycatholic

just changed my LED's inside they look amazing! JUST DON'T TWIST THEM! i just spent like an hour trying to get them back after twisting and knockin them out!

SquallLHeart

hmm... it takes a few seconds to pull down on the whole assembly to get the part back out..

common mistake.. i think we're up towards the millionth one that's twisted it?

crazycatholic

haha i didn't take it out! i just hit the roof til they jumped back up there and i pulled them in!

georgeo

hey i just changed my back dome light to the blue led, but it lights up on the door position.it is not fully on but you could see it shining a little bit.

crazycatholic

try rotating it... mine did that and i just took the cover off and turned the bulb so that the LED's were facing down

georgeo

i tswisted then turn them but nothing still the same should i leave it like that or shoul i just turn it of .

crazycatholic

i dunno... did you try flippin it around? maybe it's in backward

mdickson81

I did mine last night, it was fine but I would ahve to agree try turning it around. Also are the points in the slotted holes? Maybe you are not getting enough juice.