I tried to install it today, and it won't fit in because the filter hits the back of the fog light assembly. I popped out the fog light and put in the intake, but then, of course, the fog light won't go back in.

Anyone else have this problem? I searched and found nothing. Any help would be great.

weird, no problem here, i have fogs an injen sri

I don't know what exactly I could be doing wrong. Its a pretty straight forward install. It will only go on one way, without much wiggle room in any direction. . Everything looks the way it should, it just seems like the filter is too big maybe.

It's a little tight getting it in...but it fits. I noticed after I initially installed it that the cone was rubbing up against the fog light, so I took out the short ram and re-adjusted it...and now...no problem.

Try sliding the cone further down the pipe.

I had a friend with a injen sri and his would pop his foglight out. Try adjusting it around and see if you could get it to fit

I guess I'll mess around with it some more, see what happens. Thanks.

Try turning the pipe so it sits at a different angle. I'll be willing to bet that will fix the problem.

Try sliding the cone further down the pipe.

Yep... Slide everything closer together. It should fit.

-THE DON

Sure you didn't get an injen sri for an xA by mistake?