Yeah, i'm going to get one under the heat shield near the gas tank. It's the only other "straight" section I could add one.

 

Nice, thats a clean install. Alot better than that guy with the spintech. Im going to print those out incase i go with that type of muffler. Need better sound quality... too much distortion. It does sound good though. Drive-by?

 

Yeah, my camera picks up every little single sound and amplifies it. I'll try to have a drive by done in a bit. I might get a 12 inch resonator though. Just to cut all high end noise out and just have an SRT sound.

 

I've got 2 drivebys slowly uploading in photobucket and one more idle vid. Almost no distortion. But I think I need another resonator. A little rasp is coming out.... ah well

 

2 more coming later on.

 

That camera doesnt do it any justice. But if u can listen past the distortion it sounds good. Definatley different. If u put a second resonator on it would sound a lot deeper. Well see how the spiral flow sounds on mine. Im going to install that before i replace the muffler.

 

Ok, b/c if that sounds good, i'm going to get a 12 inch resonator from Vibrant and get that welded on. I have a good bit of rasp now. Oh well. I honestly believe it gave me a bit more high end HP due to it not being restricitve at all. I can definately gain some speed quick from 65-100 compared to how it was.

Drive by 2:

 

Yeah u can hear the rasp in that one...

 

http://www.prostreetonline.com/buy/v...ator/vib-1792/

That's the resonator I was looking at getting. Anyone have a better/cheaper site?

 

Bsmntcuts: Did you get the resonator/muffler installed yet? I'm anxious. I found a 12 inch dynomax muffler/resonator bullet form Part# 24215 for 42$.

My rasp is loud when it's a cold start. But the exhaust is really loud now at WOT from 2nd-4th..........

 

Nope, the spiral flow is in the mail right now. It will be here on wed. Getting it installed on thurs... Precisionmuffler.com has resonators for cheap. You have to e-mail them for a price though. Summitracing.com has a pretty nice selection. Thats where i got my spiral flow. I would say that $60 for that vibrant is too much... precisionmuffler.com has 30" resonators for about $30. I would go there or summit

 

For some reason, I can't pull up precision muffler's page. If I got the 30 inch resonator, that would have to be "spliced" into the pipe right after the CAT. The one that our pipe comes with is pretty long anyways right? I thought it was about 18 inches long. I was just gonna get another 12 inch resonator and put it after the second flange. What would be best b/c my 40 series is definately showing it's bark now. Pretty loud. I want to muffle it just a bit.

 

Dont get a 30" resonator, I was just giving a cost example. its better if you have 2 seperate ones... Just add a 12-18 inch to the existing resonator.

 

Yeah im having trouble viewing the site too. The guy who runs it has an account here on SL. His username is Stylis. You can PM him

 

I just got a magnaflow muffler. It's 14 in (20 inch) overall. 4 inches round and got it for 60$ shipped. Supposed to be a good sound suppresent. We'll see how it goes.

 

Link?

 

http://www.a-1performance.com/magnaf...transition.cfm

4th one in from left on top row. 2.5 I/O, 14 in length/ 20 inch overall..........that's going right in front of the rear axle

 

Mine's due in on Friday so I might either get it on Saturday morning or Monday if I can leave work a few hours early. We'll see.

I can't wait b/c I've noticed now that after the exhaust has "settled" in to having the new flowmaster, it's so wide open than it's lost a bit of torque. HP is there at high speeds, but I mean more around 80+ rather than 60ish. So, with this muffler/resonator I'm getting, I'm hoping it slows the exhaust a bit and drowns it out to give me back the hp/tq and more of a deep sound rather than just rasp.

 

Just got my spiral flow in this morning. Im going to try and get it put on tonight. If not, it will be done tomorrow morning. Will post pics/vids tomorrow.

 

Great.