yo cliff,
What difference is there in the 9006 bulbs for the 07 accords??

 

The 07+ accords/civics have headlight housings that do not fit most 9006 HID bulbs due to the shallow design. For this reason, special 9006 bulbs are available and most likely the 9006 bulbs offered in the future will be this new special HID bulb design.

Thanks.

Clifford

 

are you ever going to post results of that big hid test you did?

 

what hid kit do i need for a 02 focus, will be ordering soon for my friend as soon as i pick up the cash for him.

 

DANG! i think i will buy 2 kits!

 

Maxim, great question. I'll post up results in the next few weeks, been super busy with the holidays and just got a new shirt design out for fun.

What do you think?



Here's another one that I had done earlier this year.


Ragingbull- the 02 Ford Focus requires an H4 bulb. Thanks man.

ryuji16 - PM'd you back.

Thanks all!

Clifford

 

just ordered an H4 4300k and 9006 4300k. now i gotta wait for the paypal to clear. hot dayam im excited

 

i was wondering if you could get the purple bulbs in different bulb sizes – i only found it in 9006 while going through the website

 

Dude Cliff! I Love that Mikey Mao Shirt!!!! im feelin the halogens sucks shirt also. You sellin these shirts? Would love the mao shirt.

 

love the mickey mao, the mobile hid one is too plain, spice it up a bit

 

My kit came in the mail today I'll get it installed tomorrow and put up a couple of pics.

 

Just got the kit in and am going to install it tomorrow...

 

May be a noob question.. but what plugs into the remote turn-on plug?

 

Glad you like the shirts guys. The picture is actually a little smaller in the final product because that was just too big.

Silv3r, you'll want to plug that into the OEM headlight plug and you will only use the one on the side of the battery.

 

Just ordered the H4 Kit, when will you have it shipped?

 

My filthy car before pic...


My filthy car after pic...

 

sweet. looks awesome. about my same reaction when i installed mine.

once you go HID, you wont go back!

 

i'm a total noob, but how do the strobes go in? is there a diy anywhere?

 

Clifford,

The Installation Guide appears to be Generic and am having difficulties following along.
Requires more pics for the unexperienced.

Install Questions for the 1st gen xB:

1. My headlights have a rubber boot around them. I start on the Passenger side. After pulling off the boot. I can only undo the top clip and can't see the other to get the lamp away. Am I suppose to remove the small Phillips screw holding the clip?

2. If I am successful to pop out the lamps, then What? Am I suppose to disconnect the lamps from the Factory harness? What plugs in the Passenger side harness? What plugs into the Driver's side harness?

3. The two HID lamps are not identical. Which is the Driver's side lamp? Which is the Passenger's side lamp? What plugs into those? Very confusing because the Installation Guide appears to be incomplete.

4. Where does the Ground on the harness go? Looks like on the diagram, it is connected to the - battery post? Or can I use any frame ground instead?

TIA,

MR LUV

 

I shall soon be a (im sure) proud owner of a set of 6K HIDs. Placed my order a few minutes ago. :-D